Black Nylon: Temp. Range Low – 50°F   High 275°F
                                  Pressure 150psi
                                  Ford, GM, & DaimlerChrysler Approved
                                  Automotive Approvals

Black Nylon fittings are widely used for automotive and marine applications as well as general fluid handling. Black Nylon fittings are made from the same material formulation as Natural Nylon (see above) with the addition of a black colorant. Black Nylon fittings are manufactured for general applications which do not require NSF certification or material lot traceability certificates; they are, therefore, less expensive than Natural Nylon fittings.

EJ Black Nylon Fittings Features
• Anti-rotation device reduces wear caused by hose rotation on barb
• Single barb design provides greater stability with both single and dual inside   diameter hose
• Optimum connector insertion depth is regulated by bulkhead placement

Glass-Filled Nylon: Temp. Range Low – 50°F  High 480°F
                                  Pressure 260psi
                                  Ford, GM, & DaimlerChrysler Approved
                                  Automotive Approvals

Glass-Filled Black Nylon fittings are widely used for automotive and marine applications due to their enhanced strength and impact resistance. Optimum performance is achieved by the inclusion of uniformly dispersed glass fibers throughout the fitting which are bonded to the nylon through the use of coupling agents. This process was designed to assure retention of the nylon's physical properties under a wide variety of environmental conditions.

EJ Glass Filled Black Nylon Fittings Features
• Heat resistant to temperatures of up to 480°F
• Anti-rotation device reduces wear caused by hose rotation on barb
• Single barb design provides greater stability with both single and dual inside   diameter hose
• Optimum connector insertion depth is regulated by bulkhead placement
• Glass reinforcement increases impact resistance

White Nylon fittings exhibit the same physical and chemical resistance properties as Natural Nylon. These fittings contain a percentage of recycled material sourced from our Natural Nylon, virgin material production runs. A white colorant is added to differentiate our White Nylon fittings from Natural Nylon fittings. If your application does not require lot traceability or NSF certification, these fittings represent an excellent value. White Nylon fittings are manufactured to the same tolerances and high quality standards as all EJ fittings.